clapboards

clapboards[ˈklæpbɔ:dz] 

原级:clapboard

clapboards 基本解释
墙板,隔板,桶板( clapboard的名词复数 );
clapboards 双语例句

1. But this time I found something at last; I found an old rusty wood-saw without any handle; it was laid in between a rafter and the clapboards of the roof.
    不过这一回啊,我终于找到了一样东西。我找到了一把生满了锈的旧锯子,连把子也没有。是搁在一根缘子和屋顶板中间的。

2. The water chamber takes the shape of tilting cube, in favor of uniform distribution of cooling water on tube plate surface. The tube bundle is divided into two groups of zygomorphy according to the bisection system and it has eight support clapboards. The siphonopore center of each clapboard increases a certain distance corresponding to that of two tube plates and the cooling tube takes the shape of arch. The two-way cooling water of bisection flows through the condenser in opposite direction so as to improve the distribution of heat load for tube bundle. Around the throat of condenser, the final stage low-pressure heater, air extraction tube, intake device of bypass exhaust and the like are deployed.
    它的特点是:水室呈倾斜立方体形状,有利于冷却水流在管板面上均匀分布;由于采用对分制,管束相应地分为左、右对称的两组,并且管束设有八块支撑隔板,每块隔板的管孔中心相对于两端管板的管孔中心依次抬高一定的距离,以使冷却管呈拱形状;对分制的两路冷却水以相反方向流过凝汽器,从而改善管束的热负荷分布;在凝汽器喉部布置了末级低压加热器,抽汽管道及旁路排汽接受装置等。

3. This they have converted into a thing of dingy clapboards with a narrow, low-pitched roof. And the whole they have set upon thin, preposterous brick piers.
    他们把直立的砖块作为造房的模式,造出了一种用肮脏的护墙板围成的不伦不类的房屋,屋顶又窄又平,而且整个地安放在一些单薄的、奇形怪状的砖垛上。

clapboards的近义词

4. When the wainscots and the clapboards of the box structure are welded, wainscots can be born out and un-fusion will take place in the welder.
    箱形截面构件壁板与隔板电渣焊时,易产生壁板烧穿和焊缝未熔合现象。

5. The wind had ripped away the clapboards and exposed the studding.
    风刮掉了护墙板,显露出壁骨材料。

6. Effect of different clapboards structure in turbine blade trailing edge complex passages on flow characteristics
    背压对缩放型流道涡轮动叶激波结构的影响涡轮叶片尾缘复合通道隔板结构对流动的影响

clapboards的意思

7. The compensating rings of axle bush are redesigned and interval between impellers and clapboards are adjusted.
    重新设计轴瓦补偿圈,调整叶轮与隔板之间的间隙;